Key Switch - Toro Field Pro 6040 Service Manual

Key Switch

Testing the Key Switch
Field Pro® 6040
22267SL Rev A
POSITION CLOSED
CIRCUITS
OFF NONE
RUN B + I + A and X + Y
START B + I + S
The key switch is located on the control panel and has 3 positions: O
and S .
TART
1. Park the machine on a level surface, lower any attachments, engage the
parking brake and set the key switch to the O
2. Disconnect the battery negative (-) cable at the battery; refer to
and Installing the Battery (page
3. Disconnect the wire harness connector from the switch. Check the switch
and the harness connector for damage or corrosion and clean or repair if
necessary. Remove the switch from the console if necessary.
4. Use a multimeter (ohms setting) and the preceding table to determine
whether continuity exists between the various terminals for each switch
position.
5. Replace the switch if necessary.
6. If the switch tests correctly and a circuit problem still exists, check the wire
harnesses; refer to
7. Install the switch and connect the wire harness after testing.
8. Connect the battery negative (-) cable at the battery.
6–29).
Appendix A (page A–1).
Page 6–9 Electrical System: Testing the Electrical Components
FF
position.
FF
Removing
, R ,
UN