Checking The Hydraulic-Fluid Level - Toro Z Master 7500-D Series Setup Instructions

6
Checking the
Hydraulic-Fluid Level
No Parts Required
Procedure
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Move the motion-control levers to the
N - position and start the engine.
EUTRAL LOCK
Note:
Run the engine at the lowest possible
rpm to purge any air in the system.
Important:
Do not engage the PTO.
3. Raise the deck to extend the lift cylinders, shut
off the engine, and remove the key.
4. Raise the seat to access the hydraulic-fluid tank.
5. Remove the hydraulic-tank cap
1. Hydraulic-tank cap
2. Dipstick
6. Remove the dipstick and wipe it with a clean rag
(Figure 3).
7. Place the dipstick into the filler neck, remove it,
and check the fluid level
Note:
If the level is not within the notched area
of the dipstick, add enough high-quality hydraulic
fluid to raise the level to within the notched area.
Important:
Do not overfill.
(Figure 3).
Figure 3
3. Filler neck
(Figure 4).
1. Full line
8. Replace the dipstick and thread the fill cap
finger-tight onto the filler neck.
9. Check all hoses and fittings for leaks.
g227849
4
Figure 4
2. Add line
g228816