Muse M-150 CR - Dual Alarm Clock Radio Manual

LOCATION AND DESCRIPTION OF CONTROLS

Please read the instruction carefully before operating the unit.

1. LED display
2. Standby/stop
   Radio on/off
3. alarm 2 / volume down
4. alarm 1 / volume up
5. Nap
   to fell asleep with the radio
6. Dimmer light intensity of the screen
   SNOOZE Interval alarm repetition
7. Setting the clock
   Memorization
8. HR. Hour setting
   Setting down
9. MIN. Minute setting
   Setting up
10. auto scan and preset radio stations
11. speaker
12. battery
13. AC Power Cord and FM antenna

POWER SUPPLY

AC: 230V 50 Hz (CE)
DC: 2x1.5V, battery type AAA/R03/UM4 (not provided) for back-up.
For optimal performance, Alkaline batteries are recommended. These batteries must be replaced every six months.

1. Insert the plug of power cord into a standard wall outlet.
2. Install the backup batteries in their compartment. Use only the size and type of batteries specified. Respect the polarity indicated in the compartment. Improper polarity can cause damage to the device. Do not attempt to recharge the batteries, they can catch fire or explode.

BACKUP SYSTEM: All settings are memorized, however, the clock time could occasionally need to be readjusted. In case of power failure, if backup batteries are not installed, the screen will flash to indicate this power failure and the necessity to redo your settings.

SETTING THE TIME

1. In standby mode, press and hold button, the display will flash, set the time with HR. hour and/or MIN. minutes.
2. Press again to confirm.

NOTE: If during the adjustment time no key is activated in 9 seconds, the current display will be automatically stored.

LISTENING TO THE RADIO

Manual search

1. Press button to turn on the radio.
2. For best reception, extend the FM wire antenna.
3. Adjust the volume by or to the desired level.
4. Choose your radio station with or .
5. To stop listening to the radio, press again.

Automatic search

Press and hold for few seconds or . The automatic search locates strong stations. A station with a weak signal can be set manually by repeatedly pressing or .

NOTE: During the search operation, the sound level is automatically muted.

Preset stations

This unit can store 20 FM stations.

Manual storage

1. Select a radio channel manually or in automatic search.
2. Press . "P 01" blinks on the screen.
3. Press or to select a channel.
4. Press to save it.
5. Repeat steps 1-4 to store other stations.

Automatic storage

Press and hold for few seconds and the unit will automatically save the first 20 FM stations. When you store on a channel already been preset, the previous station will automatically be cleared and replaced by the new station.

Listen to station presets

Press and repeat the operation as many times as necessary to select your station.
Press or to adjust sound level.

SETTING THE ALARM AND THE ALARM MODE

1. In standby mode, press and hold for a few seconds , the display blinks.
2. Press HR. and/or MIN. to set the time of wake up.
3. Press then press or to select the source of wake up buzzer, or FM radio.
4. Press to confirm, the alarm indicator lights up.

Note: Same procedure applies for Alarm 2 with button.

Note:

• The previous level of listening is stored, the volume of the alarm will be identical. If you wake up with the radio, do not forget to check the volume level.
  Press and or then press again .
• If you use the sleep mode with low sound level, you should use the buzzer to wake you up.

STOPPING THE ALARM

1. 1-Alarm repetition
   Press SNOOZE. The alarm stops and will sound again 9 minutes later.
2. Alarm stop
   Press or . The alarm 1 will sound again the next day at the same time.
3. Alarm Cancellation
   In standby mode, press to cancel the alarm 1 permanently. The alarm indicator lights off.

Note: Same procedure applies for Alarm 2 with button.

SLEEP FUNCTION

To fall asleep with the radio, Press then to select 120-90-6030-15-10 or 5 minutes of listening. Indicator lights up. The unit will automatically turn off after the specified time. To cancel the sleep function, press then to OFF.

NAP FUNCTION

This function wakes you up after a short period of time. Only the buzzer may be selected.

1. Standby mode. Press to select 120-90-60-30-15-10 or 5 minutes for your nap. The indicator lights nap.
2. To stop the alarm, press or .
3. To cancel the function, press repeatedly until OFF is displayed.

DIMMER

Press to select the brightness of the screen: HIGH, LOW, or OFF.

TECHNICAL SPECIFICATIONS

POWER SUPPLY:
AC 230V 50Hz, 4W consumption
DC 3V 2x1.5V, battery type AAA/R03/UM4 (not included) for back up.

RADIO:
FM: 87.5-108MHz

DIMENSION:
120(L) X 67(W) X 77(H) mm

MORE INFORMATION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

To reduce the risk of electric shock, do not open the device, there is no party inside for the user. Refer all servicing to qualified personnel.

The lightning with the arrow symbol in the triangle is a warning sign alerting the user to "dangerous voltage" inside the unit.

The exclamation point in the triangle is a warning sign alerting the user of important instructions accompanying the product.

IMPORTANT

• The Marking plate is located at the bottom of the device.
• Make sure to have a minimum distance of 5 cm around the unit for sufficient ventilation.
• Ensure that the ventilation openings is not covered with items such as newspapers, tablecloths, curtains, etc.
• Do not place naked flame sources, such as lighted candles on the apparatus.
• Do not expose this appliance to dripping or splashing water.
• Do not place objects filled with liquids, such as glass, vase on the device.
• Do not throw batteries into fire! Respect the environment when disposing of used batteries.
• Batteries should not be exposed to excessive heat such as sunshine, fire or other similar heat source.
• The power plug is used as a disconnect device and must be easily accessible. To be completely disconnected from the power, the plug of the appliance should be disconnected completely. The socket must not be obstructed and should be easily accessible during intended use.
• Under the influence of fast transient and / or electrostatic electric phenomenon, the product may malfunction and the user must perform a power reset of the device.

If in the future, you need to get rid of this product, please note that Waste electrical products should not be disposed of with household waste. Recycling facilities exist. Check with your municipality or ask your dealer for advice.
(Directive for Waste Electrical and Electronic Equipment)

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Muse M-150 CR - Dual Alarm Clock Radio Manual