Muse M-12 CR - Alarm Clock Radio Manual

LOCATION AND DESCRIPTION OF CONTROLS

Read the instructions carefully before operating the unit.

1. LED display
2. Standby/stop
   Radio on/off
3. alarm 2 / volume down
4. alarm 1 / volume up
5. Nap
   to fell asleep with the radio
6. Dimmer light intensity of the screen
   SNOOZE Interval alarm repetition

7. Setting the clock
   Memorization
8. HR. Hour setting
   Setting down
9. MIN. Minute setting
   Setting up
10. auto scan and preset radio stations
11. speaker
12. battery
13. AC Power Cord and FM antenna

POWER SUPPLY

AC: 230V ~ 50 Hz (CE)
DC: 2x1.5V, battery type AAA/R03/UM4 (not provided) for back-up.
For optimal performance, Alkaline batteries are recommended. These batteries must be replaced every six months.

BACKUP SYSTEM: All settings are memorized, however, the clock time could occasionally need to be readjusted. In case of power failure, if backup batteries are not installed, the screen will flash to indicate this power failure and the necessity to redo your settings.

SETTING THE TIME

1. In standby mode, press and hold button, the display will flash, set the time with HR. hour and/or MIN. minutes.
2. Press again to confirm.

NOTE: If during the adjustment time no key is activated in 9 seconds, the current display will be automatically stored.

LISTENING TO THE RADIO

Manual search

1. Press button to turn on the radio.
2. For best reception, extend the FM wire antenna.

Automatic search
Press and hold for few seconds or . The automatic search locates strong stations. A station with a weak signal can be set manually by repeatedly pressing or.
NOTE: During the search operation, the sound level is automatically muted

Preset stations
This unit can store 20 FM stations.

Manual storage:

Automatic storage:
Press and hold for few seconds and the unit will automatically save the first 20 FM stations. When you store on a channel already been preset, the previous station will automatically be cleared and replaced by the new station.

Listen to station presets
Press and repeat the operation as many times as necessary to select your station.
Press or to adjust sound level.

SETTING THE ALARM AND THE ALARM MODE

1. In standby mode, press and hold for a few seconds , the display blinks.
2. Press HR. and/or MIN. to set the time of wake up.
3. Press then press or to select the source of wake up buzzer, or FM radio.
4. Press to confirm, the alarm indicator lights up.
   Note: Same procedure applies for Alarm 2 with button.

Note:

• The previous level of listening is stored, the volume of the alarm will be identical. If you wake up with the radio, do not forget to check the volume level.
  Press and or then press again .
  If you use the sleep mode with low sound level, you should use the buzzer to wake you up.

STOPPING THE ALARM

1. Alarm repetition
   Press SNOOZE. The alarm stops and will sound again 9 minutes later.
2. Alarm stop
   Press or . The alarm 1 will sound again the next day at the same time.
3. Alarm Cancellation
   In standby mode, press to cancel the alarm 1 permanently. The alarm indicator lights off.
   Note: Same procedure applies for Alarm 2 with button.

SLEEP FUNCTION

To fall asleep with the radio, Press then to select 120-90-60-30-15-10 or 5 minutes of listening. Indicator lights up.
The unit will automatically turn off after the specified time. To cancel the sleep function, press or to OFF.

NAP FUNCTION

This function wakes you up after a short period of time. Only the buzzer may be selected.

1. Standby mode. Press to select 120-90-60-30-15-10 or 5 minutes for your nap. The indicator lights nap.
2. To stop the alarm, press or .
3. To cancel the function, press repeatedly until OFF is displayed.

DIMMER

Press to select the brightness of the screen: HIGH, LOW, or OFF.

TECHNICAL SPECIFICATIONS

POWER SUPPLY: AC 230V~50Hz, 4W consumption DC 3V 2x1.5V, battery type AAA/R03/UM4 (not included) for back up.
RADIO: FM:87.5-108MHz
DIMENSION: 130(L) X 70(W) X 59(H) mm