Muse M-187 CR, M-187 CLG - Dual Alarm Clock Radio Pll Manual

LOCATION AND DESCRIPTION OF CONTROLS

1. Alarm 1 indicator
2. Alarm 2 indicator
3. SNOOZE indicator
4. FM indicator
5. MW indicator
6. Sleep indicator
7. Nap indicator
8. LED display
9. Nap
   To fall asleep with the radio
10. Setting the clock
    Memorisation
11. HR. Hour setting
    Setting down
12. MIN. Minute setting
    Setting up
13. auto scan and preset radio stations
14. Standby
    band selector: FM/MW/AUX
15. volume down
16. volume up
17. alarm 2
18. alarm 1
19. Dimmer light intensity of the screen SNOOZE Interval alarm repetition
20. AUX IN jack (3.5mm)
21. FM wire antenna
22. AC power cord
23. Battery compartment
24. Speaker

POWER SUPPLY

AC: 230V 50Hz
DC: 2x1.5V, battery type AAA/R03/UM4 (not provided) for back-up
For optimal performance, alkaline batteries are recommended.
These batteries must be replaced every six months.

1. Insert the plug of power cord into a standard wall outlet.
2. Install the batteries in their compartment. Use only the size and type of batteries specified. Respect the polarity indicated in the compartment. Improper polarity can cause damage to the device. In order to avoid leakage, remove the batteries when unit will not be used for a long period of time. Do not mix different types of batteries or old batteries with new ones.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

BACKUP SYSTEM: All settings are memorized, however, the clock time could occasionally need to be readjusted. In case of power failure, if backup batteries are not installed, the screen will flash to indicate this power failure and the necessity to redo your settings.

TURNING UNIT ON/OFF

In standby mode, press once to turn on the unit. Press and hold for 2 seconds to turn off the unit.

SELECTING FUNCTION

When the unit is ON, press button repeatedly to select the desired function in cycle: FM, MW, AUX.

SETTING THE TIME

1. In standby mode, press and hold button, the display will flash. Set the time with HR. hour and/ or MIN. minutes.
2. Press again to confirm.

NOTE: If during the adjustment time no key is activated in 5 seconds, the current display will be automatically stored.

LISTENING TO THE RADIO

Band selection

When the unit on, repeatedly press button to select FM or MW band.

Manual Search

1. Press once to turn on the radio.
2. Press button again to select your desired band.
3. Adjust the volume by or to the desired level.
4. Choose your radio station with or .

To enhance radio reception ability

FM: Extend the FM antenna.
MW: Rotate the unit horizontally for optimum reception.

Automatic search

Press and hold for few seconds or , the automatic search locates strong stations. A station with a weak signal can be set manually by repeatedly pressing or .

NOTE: During the search operation, the sound level is automatically muted.

Preset stations

This unit can store 10 FM and 10 MW stations.

Manual storage

1. Repeatedly press button to select FM or MW band.
2. Select a radio station manually or in automatic search.
3. Press . "P 01" blinks on the screen.
4. Press or to select a channel.
5. Press to save it.
6. Repeat steps 1-5 to store other stations.

Automatic storage

In FM mode, press and hold for few seconds and the unit will automatically save the first 10 FM stations. When you store on a channel already been preset, the previous station will automatically be cleared and replaced by the new station.
Note: same procedure applies for MW automatic storage when in MW mode.

Listening to station presets

Press button to select FM or MW band. Then press and repeat the operation as many times as necessary to select your station.
Press or to adjust the sound level.

SETTING THE ALARM AND THE ALARM MODE

1. In standby mode, press and hold for a few seconds the display blinks.
2. Press or to select the source of wake up buzzer, or radio.
3. Press then Press HR. and / or MIN. to set the time of wake up.
4. Press to confirm, the alarm 1 indicator lights up.

Note:

• Same procedure applies for alarm 2 with button.
• If you wake up with the radio, select your desired station, then long press button to turn off the radio before the alarm time reaches. For the station selecting, please refer to "LISTENING TO RADIO".
• The previous level of listening is stored, the volume of the alarm will be identical. If you wake up with the radio, do not forget to check the volume level. Press and or then press again .
• If you use the sleep mode with low sound level, you should use the buzzer to wake you up.

Stopping the alarm

1. Alarm repetition
   Press SNOOZE. The alarm stops and will sound again 9 minutes later.
2. Alarm stop
   Press or . The alarm1 will sound again the next day at the same time.
3. Alarm Cancellation
   In Standby mode, press to cancel the alarm1 permanently. The alarm1 indicator lights off.
   Note: Same procedure applies for Alarm2 with button.

SLEEP FUNCTION

To fall asleep with the radio, Press then to select 120-90-6030-1510 or 5 minutes of listening. Indicator lights up. The unit will automatically turn off after the specified time. To cancel the sleep function, repeatedly press button until "OFF" display or Long press button until indicator lights off.

NAP FUNCTION

This function wakes you up after a short period of time. Only the buzzer may be selected.

1. In standby mode, press to select 120-90-60-30-15-10 or 5 minutes for your nap. The indicator lights nap.
2. To stop the alarm, press or .
3. To cancel the function, press repeatedly until OFF is displayed.

CONNECTING AUXILIARY SOURCE

1. Connect your auxiliary source (e.g. mp3 player) to the AUX IN jack on the back of unit (cable not included).
2. When the unit is on, press button on unit repeatedly to select AUX mode. The display will show " " for a few seconds and change to clock time.
3. Start playback from your auxiliary source.
4. Adjust the volume to desired level.
5. To stop playback, disconnect your auxiliary source from the AUX IN jack.

DIMMER

Press to select the brightness of the screen: high, low or off.

TECHNICAL SPECIFICATIONS

POWER SUPPLY: AC 230V 50Hz, 4W consumption
DC 2x1.5V, battery type AAA/R03/UM-4 (not provided) for back-up

RADIO: FM 87.5-108MHz MW: 522-1620kHz

Note: Design and specification are subject to change without notice.

Hereby, NEW ONE S.A.S, declares that this MUSE M-187 CR/ M-187 CLG is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at www.muse-europe.com

MORE INFORMATION

To reduce the risk of electric shock, do not open the device, there is no party inside for the user. Refer all servicing to qualified personnel.

The lightning with the arrow symbol in the triangle is a warning sign alerting the user to "dangerous voltage" inside

The exclamation point in the triangle is a warning sign alerting the user of important instructions accompanying the product.

The Caution mark is located at the back of the device.

• The use of apparatus in moderate climates.
• The Marking plate is located at the bottom of the device.
• Make sure to have a minimum distance of 5 cm around the unit for sufficient ventilation.
• Ensure that the ventilation openings is not covered with items such as newspapers, tablecloths, curtains, etc.
• Do not place naked flame sources, such as lighted candles on the apparatus.
• Do not expose this appliance to dripping or splashing water.
• Do not place objects filled with liquids, such as glass, vase on the device.
• Do not throw batteries into fire! Respect the environment when disposing of used batteries.
• Batteries should not be exposed to excessive heat such as sunshine, fire or other similar heat source.
• The power plug is used as a disconnect device and must be easily accessible. To be completely disconnected from the power, the plug of the appliance should be disconnected completely. The socket must not be obstructed and should be easily accessible during intended use.
• Under the influence of fast transient and / or electrostatic electric phenomenon, the product may malfunction and the user must perform a power reset of the device.

If in the future, you need to get rid of this product, please note that Waste electrical products should not be disposed of with household waste. Recycling facilities exist. Check with your municipality or ask your dealer for advice. (Directive for Waste Electrical and Electronic Equipment)

NEW ONE S.A.S

10, Rue de la Mission, 25480 Ecole Valentin, France