Operation; Safety Instructions; Load The Crane Scale - KERN HTS Series Operating Instructions Manual

6.

Operation

6.1

Safety instructions

6.2

Load the crane scale

For good weighing results note the following, for figures see next page:
Do use hardware that creates single point attachments and allows the scale freedom
of alignment.
Do not use oversize interface hardware which restricts single point loading.
Do not use multiple attachments.
Do not push or pull the load or the loaded scale.
Do not pull laterally on the hook.
HTS-BA-e-1024
Danger
Risk of injury due to falling loads!
Always operate with great care according to the general rules for
operating a crane, see chapter 1.
Persons are forbidden to walk or stand in dangerous area.
Do not exceed the rated load capacity of the crane, crane scale or
any load bearing
Check all parts (hook, loop, rings, rope loops, cables, chains, etc.)
for excessive wear or damage
If there are visible defects on the safety latch of the hook, or if it is
missing altogether, the scale must not be used.
Only work at the appropriate speed
You must avoid oscillations and horizontal force. Avoid any type of
impacts, twisting (torsion) and oscillations (e.g. caused by
suspending at an angle).
Do not use crane scale for transporting loads
The nature of loads, which can be handled by the equipment must
be observed.
Prohibition to use in a building area.
item attached to the crane scale.
29