Table of Contents
Advertisement
OPERATION
Legend for illust. Z 22466
(A)
Display with basic information
(B)
Key board with 8 keys. For the function of the keys
refer to page 95.
(C))
Key operated switch for enabling access to the
INPUT-OUTPUT levels and input of operational
data.
(D)
Key section with 4 keys for menu control of Service
Functions and for INPUT-OUTPUT functions (On
Screen Display).
(9)
RETURN Key, this key is used for returning to previ-
ous level of INPUT-OUTPUT or Service Functions.
(10)
QUI Key, this key is used for access to the next
lower level of INPUT-OUTPUT or Service Functions
and going back to the Standard Display from a dis-
played current message.
(11)
"0" Key, this key is used for selection of horizontal
menu items within a main section of the inputs-out-
puts or service levels (LH direction).
(12)
"1" Key, same function as key (11) but in RH direc-
tion. Refer to page 127 Menu Control, for more infor-
mation about the key section (D).
Acoustic warning signal (Buzzer)
(13)
This signal is heard for approximately 1 second
when a fault message appears on screen (B).
Continuous sound when the hydraulic oil level is
too low.
In case of too low hydraulic oil level this signal
sounds continuously. Shut down the Shovel,
locate and correct the cause immediately. Fill up
hydraulic oil to the correct level.
(14)
Switch for truck counter on RH control lever. The
loaded trucks can be counted by actuating this
switch. The total number of trucks loaded will then
be displayed on screen (A) for five seconds.
(E)
Plug socket for connecting remote printer or other
data downloading equipment.
For printing out the contents of the Statistics mem-
ory, press key (8) and key (6).For printing out the
contents of the Protocol memory, press keys (7, 6
and 3). Keep key (3) depressed until all messages
are selected and then press key (6) two times. Refer
also to page 117 for more detailed information.
3.4 ELECTRONIC MONITORING AND CONTROL SYSTEM ECS
CAUTION
93
Advertisement
Table of Contents
