Table of Contents
Advertisement
OPERATION
RECEIVER PANEL WITH MONITOR BOX
Legend for illust. Z 22469
20
Adapter for filling the water tank in the Operator's cab.
The water tank has a capacity of 50 liters. The filling line
of the water tank is equipped with a drain cock. Before
filling the water tank, drain the old water by opening this
drain cock. Close the drain cock and fill in 50 liters of
clear water. The tank can also be filled through a filler
opening in the Operator's cab.
NOTICE
If freezing temperatures are expected, drain the water from
the filling line by opening the drain cock. Switch on the
engine-independent auxiliary cab heater during standstill
periods to prevent freezing of the water in the cab water tank.
DO NOT drink the water from the water-tap in the
Operator's cab.
Use for hand washing only.
REMARK
The overflow line of the hand wash sink and water tank must
not be obstructed. The overflow line is routed inside the cab base
through a hole in the base floor to the outside. Excess water will
flow through this line to the outside just below the cab base.
Refilling Procedure:
REMARK
Refer to Maintenance section 4, for the correct lubricant spec-
ifications and filling capacities.
For Engine Lubricants and Coolants refer to the separate Engine
Operation & Maintenance Manual in part 3 of this Binder.
1. Connect supply lines to the respective adapters.
2. Monitor the respective fluid/lubricant level at the indicator
lights (7, 12, 14 and 16).
3. After finishing the refilling operation, cover the adapters with
the protection caps provided and swing back hydraulic ser-
vice arm (3) to its home position.
Recheck fluid levels before operating the machine.
WARNING
CAUTION
3.18 CENTRAL REFILLING SYSTEM
275
Advertisement
Table of Contents
