Elecrow Raspberry Pi & Arduino Starter Kit User Manual page 94

Table of Contents

Advertisement

Hardware required
For this lesson we'll need to use the IR receiver which looks like a small LED with black pin on the end of it (don't
confuse it with the flame sensor we used earlier, it has 2 pins) as well as the remote control to send the signals to
the IR receiver to accept.
Material diagram
Material Name
IR Remote
IR Receiver
Raspberry Pi Board
T-Cubbler Plus
40P GPIO Cable
94 of 114
Number (amount)
1
1
1
1
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Raspberry Pi & Arduino Starter Kit and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents