By running the program it will show the value of the potentiometer, to change the value need to turn the
potentiometer physically left or right, this will change his value.
LESSON 20: WATER LEVEL MONITORING
Introduction
This is a water level measurement experiment, it is relatively simple to achieve, only need to read the value of the
analog port (A0 or others), and then converted to a percentage.
We'll be using the PCF8591 module as well for the water level monitoring example.
Specification
Operating voltage: DC3-5V
Operating current: less than 20mA Sensor Type: Analog
Production process: FR4 double-sided HASL Humidity: 10% -90% non-condensing Detection Area: 40mmx16mm
Product Dimensions: 62mmx20mmx8mm
85 of 114
Need help?
Do you have a question about the Raspberry Pi & Arduino Starter Kit and is the answer not in the manual?