Table of Contents
Advertisement
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3)
Press the <ENTER> button.
4)
Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3)
Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[ANGLE MONITOR]
4)
Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (x page 281)
Changes the setting of the <REMOTE 2 IN> terminal.
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 191)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input is SDI
g The [DISPLAY OPTION] menu → [SLOT IN] → [SYSTEM SELECTOR]
f When the input is anything other than SDI
The [PICTURE] menu → [SYSTEM SELECTOR]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 99)
Temporarily pauses the image. (x page 143)
Displays the waveform of the input signal. (x page 143)
Loads the registered lens memory. (x page 147)
Switch the aspect ratio of the image. (x page 105)
Switches the [PROJECTION METHOD] setting. (x page 145)
Switches the [GEOMETRY] setting. (x page 107)
Displays the [ANGLE MONITOR] screen. (x page 179)
Displays the type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source 1 and the light source 2.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
ENGLISH - 175
Advertisement
Table of Contents
