[Wired Lan] - Panasonic PT-REQ12 Series Operating Instructions Manual

[EXTRON XTP]
Perform the connection setting for the "XTP transmitter" of Extron Electronics.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [EXTRON XTP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f For details of the "XTP transmitter", visit the following website of Extron Electronics.
https://www.extron.com/

[WIRED LAN]

Perform the connection setting to use the wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
3) Press as to select [IP VERSION].
4) Press the <ENTER> button.
f The [IP VERSION] screen is displayed.
5) Press as to select the item to set, and press the <ENTER> button.
[IPv4]
[IPv6]
[IPv4 & IPv6]
6) Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
f Proceed to Step 12) when [IPv6] is selected.
7) Press as to select [IPv4 SETTINGS], and press the <ENTER> button.
f The [IPv4 SETTINGS] screen is displayed.
8) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
9) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
Chapter 4 Settings — [NETWORK] menu
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK IN/LAN> terminal.
Select this item when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK
IN/LAN> terminal.
Uses only the "IPv4" protocol.
Uses only the "IPv6" protocol.
Both the "IPv4" and the "IPv6" protocols can be used.
[ON]
[OFF]
Enter the IP address.
Enter the subnet mask.
Enter the default gateway address.
Select this item when using the DHCP server that exists in the
network to which the projector is to be connected. IPv4 address is
automatically acquired.
Select this item when setting the IPv4 address manually.
Set [IP ADDRESS], [SUBNET MASK], and [DEFAULT GATEWAY].
ENGLISH - 197