Table of Contents
Advertisement
Note
f When [LOCK] is set to [ON], signal deletion and image adjustment are not available. To perform these operations, set [LOCK] to [OFF].
f A signal can be registered to the sub memory even if it is protected.
f Even a protected signal will be deleted if [INITIALIZE] is executed.
Sub memory
The projector has a sub memory function that can register the multiple image adjustment data, even if it is
recognized as the same signal by the frequency or format of the synchronization signal source.
Use this function when you need to switch the aspect or adjust the picture quality such as the white balance
while using the same signal source. The sub memory includes all the data that can be adjusted for each signal,
such as the image aspect ratio and data adjusted in the [PICTURE] menu (items such as [CONTRAST] and
[BRIGHTNESS]).
Registering to the sub memory
1)
While in the normal screen (where no menu is displayed), press qw.
f The sub memory registration screen is displayed if the sub memory is not registered. Proceed to Step 3).
f A list of sub memories registered to the signal currently input is displayed.
f The <FUNCTION> button on the remote control can be used instead of the qw button when [SUB
MEMORY] is selected from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON].
2)
Press asqw to select the sub memory number to register in [SUB MEMORY LIST].
3)
Press the <ENTER> button.
f The [SIGNAL NAME CHANGE] screen is displayed.
4)
Press asqw to select [OK], and press the <ENTER> button.
f To rename the registered signal, follow the procedure in Steps 6) and 7) in "Renaming the registered signal"
(x page 189).
Switching to the sub memory
1)
While in the normal screen (where no menu is displayed), press qw.
f A list of sub memories registered to the signal currently input is displayed.
2)
Press asqw to select the signal to switch in [SUB MEMORY LIST].
3)
Press the <ENTER> button.
f This switches to the signal selected in Step 2).
Deleting the sub memory
1)
While in the normal screen (where no menu is displayed), press qw.
f The [SUB MEMORY LIST] screen is displayed.
2)
Press asqw to select the sub memory to be deleted, and press the <DEFAULT> button on the
remote control.
f The [REGISTERED SIGNAL DELETE] screen is displayed.
f To cancel the deletion, press the <MENU> button to return to the [SUB MEMORY LIST] screen.
3)
Press the <ENTER> button.
f The selected sub memory will be deleted.
Chapter 4 Settings — [SIGNAL LIST] menu
ENGLISH - 191
Advertisement
Table of Contents
