Setting Up; Usable Outlet; Installation Mode - Panasonic PT-REQ12 Series Operating Instructions Manual

Setting up

Usable outlet

This projector supports AC 100 V to AC 240 V as the power supply. A grounded outlet supporting 15 A is required
with either voltage.
The shape of the usable outlet differs depending on the power supply. Following illustrations are examples.
2P/3W 15 A 250 V
2P/3W 15 A 250 V
Attention
f Use the supplied power cord and ground at the outlet.
f Use the power cord matching the used power supply voltage and outlet shape.
Note
f The supplied power cords vary depending on the country or region where you purchased the product.

Installation mode

The installation modes of the projector are as follows. Set [FRONT/REAR] / [FLOOR/CEILING] in the
[PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 145) depending on the installation mode.
Setting on a desk/floor and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
42 - ENGLISH
Chapter 2 Getting Started — Setting up
2P/3W 20 A 250 V
2P/3W 15 A 125 V
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Setting value
[FRONT]
[AUTO] or [FLOOR]
2P/3W 15 A 250 V
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Setting value
[REAR]
[AUTO] or [FLOOR]