Table of Contents
Advertisement
[ANGLE MONITOR] screen
Displays the tilt angle of the projector graphically based on the angle information detected by the built-in angle
sensor.
1)
Press the <ENTER> button while 5/6 page of the [STATUS] screen is displayed.
f The [ANGLE MONITOR] screen is displayed.
ANGLE MONITOR
+30
+20
+10
-10
-20
-30
2)
Press the <ENTER> button or the <DEFAULT> button.
f The angle benchmark will switch each time you press the button.
<ENTER> button
<DEFAULT> button
Note
f The illustration of the projector in the [ANGLE MONITOR] screen does not rotate and does not follow the attitude change of the projector.
f The illustration of the projector shows the monitor of the roll angle and the monitor of the pitch angle.
g The rear view illustration of the projector(left side): indicates the roll angle
g The side view illustration of the projector(right side): indicates the pitch angle
f The green line intersecting the illustration of the projector indicates the angle to the benchmark selected in step 2). Read the left and right
gauges.
f The red wq mark on the horizontal axis represents the benchmark surface (0°, +180°) selected in step 2).
f The values shown at the top of of the roll angle monitor and the pitch angle monitor are common with the values displayed in [ROLL ANGLE]
and [PITCH ANGLE] on the [STATUS] screen.
f The benchmark selected in step 2) remains unchanged even if the main power is turned off and on.
f [ANGLE MONITOR] screen can be displayed directly by pressing the <FUNCTION> button when [PROJECTOR SETUP] menu →
[FUNCTION BUTTON] is set to [ANGLE MONITOR].
[INDICATOR SETTING]
Set the indicator‑off function that allows the projector can be used without the indicators (power indicator <ON (G)/
STANDBY (R)>, light source indicator <LIGHT1> / <LIGHT2>, temperature indicator <TEMP>) lit or blink even
when the projector is in standby mode or projection mode.
1)
Press as to select [INDICATOR SETTING].
2)
Press the <ENTER> button.
f The warning message of the indicator‑off function is displayed.
3)
Press the <ENTER> button.
f The [INDICATOR SETTING] screen is displayed.
4)
Press as to select [INDICATOR MODE].
Chapter 4 Settings — [PROJECTOR SETUP] menu
+ 20°
+150
-150
ZERO CALIBRATION
RESET
Displays the angle of the zero calibration state representing the current installation attitude of the projector
Displays the angle of the zero calibration reset state.
Resets the zero calibration and displays the detection result of the angle sensor as it is.
- 20°
+150
+160
+160
+170
+170
-170
-170
-160
-160
-150
RETURN
+30
+20
+10
-10
-20
-30
ENGLISH - 179
Advertisement
Table of Contents
