Table of Contents
Advertisement
Maintenance
Before maintenance
f Make sure to turn off the power before performing the maintenance of the projector.
f When switching off the projector, make sure to follow the procedures in "Switching off the projector"
(x page 76).
Maintenance
Outer case
Wipe off dirt and dust with a soft, dry cloth.
f If the dirt is persistent, soak the cloth with water and wring it thoroughly before wiping. Dry off the projector with
a dry cloth.
f Do not use benzene, thinner, or rubbing alcohol, other solvents, or household cleaners. Doing so may
deteriorate the outer case.
f When using chemically treated dust cloths, follow the instructions written on its packaging.
Lens front surface
Wipe off dirt and dust from the front surface of the lens with a soft clean cloth.
f Do not use a cloth that is fluffy, dusty, or soaked with oil/water.
f Since the lens is fragile, do not use excessive force when wiping the lens.
Attention
f The lens may become damaged by hitting with a hard object or by wiping the front surface of the lens with excessive force. Handle with
care.
Note
f Dust may accumulate around the intake vent depending on the environment and operating condition when used in an environment with
excessive dust. This may adversely affect the ventilation, cooling, and heat dissipation inside the projector, thus causing reduced brightness.
262 - ENGLISH
Chapter 6 Maintenance — Maintenance
Advertisement
Table of Contents
