Table of Contents
Advertisement
10) Press qw to select [OK], and press the <ENTER> button.
f Setting for the IPv4 address is saved.
11) Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
12) Press as to select [IPv6 SETTINGS], and press the <ENTER> button.
f The [IPv6 SETTINGS] screen is displayed.
13) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[AUTO CONFIGURATION]
[TEMPORARY ADDRESS]
[IP ADDRESS]
[PREFIX LENGTH]
[DEFAULT GATEWAY]
14) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
15) Press qw to select [OK], and press the <ENTER> button.
f Setting for the IPv6 address is saved.
Note
f When using a DHCP server, confirm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, default gateway, and prefix length.
f [IPv6] in [IP VERSION] cannot be set in following cases.
g When the [NETWORK] menu → [NETWORK CONTROL] → [Crestron Connected
g When the [NETWORK] menu → [Art-Net] → [Art-Net SETUP] is set to anything other than [OFF]
f [IPv4 SETTINGS] cannot be set when the [NETWORK] menu → [Art-Net] → [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)].
f The network settings for the <LAN> terminal equipped on the projector as standard and the <DIGITAL LINK IN/LAN> terminal on the
optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) are common.
f Wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connection method of wireless LAN and its details.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50 Series) to the <USB> terminal.
1)
Press as to select [WIRELESS LAN].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
[DISABLE]
Note
f [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB> terminal.
f Maximum number of devices that can be connected simultaneously to the projector via wireless LAN is four devices.
198 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
[ON]
[OFF]
[ON]
[OFF]
Enter the IP address.
[1] - [128]
Enter the default gateway address.
Select this item when the wireless LAN is to be used.
A device such as a smartphone can be directly connected to the projector even if a wireless LAN
access point is not set up separately because the projector is used as a simplified access point.
For setting procedure of the connection key, refer to "Setting the connection key" (x page 199).
Select this item when the wireless LAN is not to be used.
Select this item when assigning the IPv6 address automatically.
Set [TEMPORARY ADDRESS].
Select this item when setting the IPv6 address manually.
Set [IP ADDRESS], [PREFIX LENGTH], and [DEFAULT
GATEWAY].
Select this item when the temporary IPv6 address is used.
Select this item when the temporary IPv6 address is not used.
Select the prefix length.
(Factory default setting: [64])
] is set to [ON]
TM
Advertisement
Table of Contents
