Table of Contents
Advertisement
7)
Press the <ENTER> button.
f The [UPPER FREE SHAPE] screen, the [LOWER FREE SHAPE] screen, the [LEFT FREE SHAPE]
screen, or the [RIGHT FREE SHAPE] screen is displayed.
8)
Press as to select [INITIALIZE].
9)
Press the <ENTER> button.
f The confirmation screen is displayed.
10) Press qw to select [EXECUTE], and press the <ENTER> button.
Note
f The adjustment data for [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE SHAPE], and [RIGHT FREE SHAPE] cannot be
initialized at once.
f To initialize all the adjustment data, select each item and execute [INITIALIZE] individually.
f When the projector is initialized by one of the following methods, all data in [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE
SHAPE], and [RIGHT FREE SHAPE] are initialized.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
[FRAME RESPONSE]
Set the processing method of the image frame delay.
1)
Press as to select [FRAME RESPONSE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[FIXED]
*1
*1 Only when video signal or computer signal with the vertical scanning frequency of 50 Hz or 60 Hz is input
[QUAD PIXEL DRIVE]
Enable/disable the QUAD PIXEL DRIVE function to enhance the resolution of the projected image.
1)
Press as to select [QUAD PIXEL DRIVE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f [QUAD PIXEL DRIVE] is fixed to [ON] in the following cases.
g When the [POSITION] menu → [GEOMETRY] is set to anything other than [OFF]
g When [CUSTOM MASKING] in [BLANKING] is set to anything other than [OFF] ([PC-1], [PC-2], [PC-3])
f [QUAD PIXEL DRIVE] is set to [OFF] when the focus test pattern or the cross hatch test pattern is displayed using the [TEST PATTERN]
menu.
To enable the QUAD PIXEL DRIVE function while displaying the focus test pattern or the cross hatch test pattern, set [QUAD PIXEL DRIVE]
to [ON] again while displaying the focus pattern or the cross hatch test pattern.
[RASTER POSITION]
This function will allow the position of the image to move within the displayable area arbitrarily when the input
image is not using the whole displayable area.
1)
Press as to select [RASTER POSITION].
2)
Press the <ENTER> button.
f The [RASTER POSITION] screen is displayed.
3)
Press asqw to adjust the position.
118 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Standard setting.
Sets image frame delay to be constant regardless of the image position or magnification.
Enables the QUAD PIXEL DRIVE function.
Disables the QUAD PIXEL DRIVE function.
Advertisement
Table of Contents
