Table of Contents
Advertisement
r Connecting terminals
1
1
<MULTI SYNC IN> terminal/<MULTI SYNC OUT> terminal
This terminal is used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
2
<SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
3
<SERIAL OUT> terminal
This is a terminal to output the signal connected to the <SERIAL
IN> terminal.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
4
<REMOTE 2 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
5
<REMOTE 1 IN> terminal/<REMOTE 1 OUT> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment.
Note
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When connecting a USB memory to the <USB> terminal, also refer to "Using the USB memory" (x page 83).
f When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [NORMAL], power can be supplied by using the <DC OUT> terminal
even while the projector is in standby mode. If [ECO] is set, power cannot be supplied in standby mode.
Chapter 1 Preparation — About your projector
2
3
4
5
8
9
7
6
10
12
11
6
Slot (<SLOT>)
There is an Intel
Smart Display Module (Intel
®
specification slot internally. Function Board supporting the Intel
SDM Small (Intel
SDM-S) or the Intel
®
SDM-L) specification can be installed.(x page 53)
7
Slot cover
8
<DC OUT> terminal
This is the USB terminal dedicated for power supply. (DC 5 V,
2 A)
Use this terminal when a power supply is required to wireless
display adapters and wireless LAN/Ethernet converters, etc.
9
<USB> terminal
This is a terminal to connect the USB memory when using the
data cloning function or firmware update function. (x pages
246, 252)
This is also the terminal to connect the optional Wireless
Module (Model No.: AJ-WM50 Series) when the projector is
connected via wireless LAN. (x page 211)
10 <HDMI IN 1> terminal/<HDMI IN 2> terminal
This is a terminal to input HDMI signal.
11 <DisplayPort IN> terminal
This is a terminal to input DisplayPort signal.
12 <LAN> terminal
This is the LAN terminal to connect to the network.
SDM)
®
®
SDM Large (Intel
®
®
ENGLISH - 37
Advertisement
Table of Contents
