[Edge Blending] - Panasonic PT-REQ12 Series Operating Instructions Manual

Blanking correction
Top of the screen
Bottom of the
screen
Left side of the
screen
Right side of the
screen
Note
f The upper limit of the adjustment range may be restricted so that the entire projected image is not covered by blanking width.
f In following cases, the [CUSTOM MASKING] setting in [BLANKING] is disabled, and the masking function in the "Geometric & Setup
Management Software" cannot be used.
g When the [ADVANCED MENU] menu → [QUAD PIXEL DRIVE] is set to [OFF]
g When the image of 1080/120p or 1920x1080/240 is displayed
"Geometric & Setup Management Software" can be downloaded from the following website.
https://panasonic.net/cns/projector/pass/
It is necessary to register and login to PASS to download.

[EDGE BLENDING]

The overlapping area is made seamless by creating inclination in the brightness in the overlapped area when
structuring a multi-display screen by combining the projected images from multiple projectors.
It is recommended that edge blending is adjusted after an image is projected continuously for at least 30 minutes
and then the image is stable.
1) Press as to select [EDGE BLENDING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
[USER]
f Proceed to Step 3) when anything other than [OFF] is selected.
3) Press the <ENTER> button.
f The [EDGE BLENDING] screen is displayed.
4) Press as to select [MODE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[SOFTEDGE/BLACK LEVEL]
[BLACK LEVEL ONLY]
114 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Item Operation
Press q.
[UPPER]
Press w.
Press w.
[LOWER]
Press q.
Press w.
[LEFT]
Press q.
Press q.
[RIGHT]
Press w.
Sets the edge blending function to off.
Use the setting value preset in the projector for the inclination of the edge blending area.
Use the user‑setting value for the inclination of the edge blending area. (Configuration/registration
requires separate software. Consult your dealer.)
Standard setting. Adjusts both the inclination of the brightness and the black level.
Select this item when adjusting only the black level. This is useful when adjusting the inclination of the
brightness with an externally connected media server, etc.
Adjustment
The blanking zone
moves upward.
The blanking zone
moves downward.
The blanking zone
moves upward.
The blanking zone
moves downward.
The blanking zone
moves to the right.
The blanking zone
moves to the left.
The blanking zone
moves to the right.
The blanking zone
moves to the left.
Range of adjustment
Top and bottom 0 - 2 398
Left and right 0 - 3 838