Connecting - Siemens SIMATIC ET 200SP Manual

11.2

Connecting

Connecting the SCRJ connector
You can find more information about the required tools, accessories, requirements and
procedures in the section Connecting BusAdapter BA 2×SCRJ (Page 34).
Connecting FC plug-in connectors
You can find more information about the required tools, accessories and procedures in the
section Connecting BusAdapter BA 2×FC (Page 20).
Pin assignment
The following table shows the signal name and description of the pin assignment of the
BusAdapter BA SCRJ/FC.
Table 11-1 Industrial Ethernet/PROFINET pin assignment with BusAdapter BA SCRJ/FC
Procedure
To connect PROFINET IO to the PROFINET device via the BusAdapter BA SCRJ/FC, follow these
steps:
1. Plug the BusAdapter BA SCRJ/FC into the PROFINET device.
2. Screw the BusAdapter BA SCRJ/FC to the PROFINET device (1 screw with 0.25 Nm
tightening torque). To do this, use a screwdriver with a 3 to 3.5 mm blade, alternatively
TX10.
3. Plug the RJ45 bus connector into the PROFINET port on the BusAdapter BA SCRJ/FC.
BusAdapter
Equipment Manual, 10/2022, A5E41449003-AC
View Signal name Description
Receive Data
①
Transmit Data
②
1 RD_N Receive Data –
2 TD_N Transmit Data -
3 RD Receive Data +
4 TD Transmit Data +
BusAdapter BA SCRJ/FC
11.2 Connecting
61