Table of Contents
Advertisement
Connecting to your base station
Connecting to your base station
The Gigaset USB Adapter DECT can be operated on the following Gigaset base stations:
Gigaset CX100/150isdn, Gigaset SX100/150isdn, Gigaset CX203/235isdn,
Gigaset SX205/255isdn, Gigaset SX303/353isdn, Gigaset 4170/75isdn and
Gigaset 3070/75isdn.
The following operating systems are supported: Windows® 98SE, Windows® NT,
Windows® ME, Windows® 2000 and Windows® XP.
Gigaset Repeater:
The Gigaset Repeater cannot be used to extend the wireless range of the
Gigaset USB Adapter.
i
Several Gigaset USB Adapters
If you are operating several Gigaset USB Adapters on a base station,
please read Chapter "Several PCs sharing a base station" on page 15.
Gigaset 3070/75isdn, Gigaset 4170/75isdn
You have to update the Gigaset SX205/255isdn firmware. The firmware will be updated
automatically if you activate the Check firmware version option during installation.
Installation
System requirements
PC with operating system Windows® 98SE, NT, ME, 2000 or XP
u
5 MB free hard disk memory
u
1 free USB socket
u
1 CD-ROM drive (or DVD drive)
u
Installing the Gigaset USB Adapter DECT
Use the installation wizard to set up your Gigaset USB Adapter. The
i
installation wizard will make sure that all the necessary settings and
additional software have been included.
The Gigaset USB Adapter should not be connected to the PC when you start installation.
During installation, the installation wizard will prompt you to insert the USB cable. If it
is already inserted, remove it and then re-insert it after a few moments.
If a dialogue window appears during installation informing you about a
i
missing signature, click Continue installation.
ì ì ì ì
Make sure your base station is in idle state.
8
Hide quick links:
Advertisement
Table of Contents
