Table of Contents
Advertisement
Plug
the
battery
according to the connector locating
system and (as shown on picture).
Verify that it locks.
Place the battery pack in its
compartment.
Close the battery compartment
trapdoor.
4.6.3 Charging the battery
When does the battery need to be charged?
/
On initial start-up, charge the battery for 16 hours under
the environmental conditions stated above
/
When used with a terminal power supply: connect the
power supply to Move/2600 power connector
How does the battery need to be charged?
/
The environment in which the charge takes place
influences battery lifetime and autonomy (number of
transactions)
The optimal conditions are as follows:
How can the battery be charged?
Using the terminal power supply
/
Connect the terminal power supply unit to the terminal
USB type C connector located above the battery door
/
Connect the power supply unit to the power supply mains
networks
/
Check to see if the battery symbol is flashing or moving
(=battery charging)
Move 2600
900050198 R11 000 02 / 0123
pack
connector
/
Charging away from any external heat source
(radiator, sun, enclosed area...)
/
The optimal temperature is between +15°C and
+25°C
16
Copyright© 2023 Ingenico -
Banks and Acquirers
International Holding SAS
All rights reserved
Advertisement
Table of Contents
