Ingenico Move/2600 User Manual page 20

5. Troubleshooting
The terminal does not turn on
Check the battery (is it discharged, is it connected?). A full
discharged battery can take long charging time to recover.
Connect terminal to terminal power supply or put it on powered
base.
Cards are not read
Check that the magnetic card is swiped correctly (with magnetic
band on terminal side).
Swipe again the card with the magnetic stripe movement
constant and rapid
Verify that the magnetic strip is not damaged, grooved or cracked
Make sure you have inserted correctly the smart card into
the smart card reader and removed the card only after the
transaction is performed.
The ticket is not printed
Check the presence and proper positioning of the paper roll.
Possibly adjust the paper roll following the instructions in this
manual (section 0 "Installing the paper roll")
Check the type of paper used (thermal paper must be used)
Verify thermal paper sensitive side.
Check battery pack is correctly connected.
www.ingenico.com
13-17 rue Pagès, 92150 Suresnes – France
Banks and Acquirers International Holding SAS / 814 767 216 RCS Nanterre
Move 2600
900050198 R11 000 02 / 0123
Copyright© 2023 Ingenico -
Banks and Acquirers
20
International Holding SAS
All rights reserved