USC LPX300 Operator's Manual page 47

The E-Stop Reset push button must be pressed after every power
cycle. After the E-Stop button has been pressed to stop a run, the
E-Stop button must be pulled out and the E-Stop RESET button
NOTICE
pressed. If both these conditions are not met, the START, HAND
and AUTO buttons will display diagonal lines through them and the
system will not function.
Le bouton-poussoir de réinitialisation E-Stop doit être enfoncée après
chaque cycle de puissance. Après que le bouton d'arrêt d'urgence a
été pressé d'arrêter une course, le bouton d'arrêt d'urgence doit être
AVIS
retiré et le bouton RESET E-Stop enfoncée. Si ces deux conditions
ne sont pas remplies, la touche START, la main et les boutons de
Auto affiche des lignes diagonales à travers eux et le système ne
fonctionnera pas.
1
2
3
4
5
1. SEED WHEEL CONTROL:
the START button will turn the seed wheel motor on and the button will turn green.
Pressing the STOP button will turn the seed wheel motor off and the button will turn
red. The round indicator displays the motor status. This module is only available if
the treater is utilizing a Seed Wheel.
2. DRUM CONTROL:
button will turn the drum motor on and the button will turn green. Pressing the STOP
button will turn the drum motor off and the button will turn red. The round indicator
displays the motor status.
3. ATOMIZER CONTROL:
START button will turn the atomizer motor on and the button will turn green. Pressing
the STOP button will turn the atomizer motor off and the button will turn red.
The round indicator displays the motor status.
LPX SEED TREATER
H-O-A (HAND-OFF-AUTO) SCREEN
This module controls the seed wheel motor. Pressing
This module controls the drum motor. Pressing the START
This module controls the atomizer motor. Pressing the
6
7
8
9
Page 47