USC LPX300 Operator's Manual page 192

To access inside of atomizer housing, push up on the quick release handle and slide
back the atomizer (below).
Slide back atomizer housing and grease

bearing inside. Bearing needs just one
pump of grease every 40 hours of use
(right).
Clean any build-up inside the housing and

the atomizer head. To remove the
atomizer head, loosen the set screw
located on the bottom of the head.
Check for any play in the atomizer shaft.

Make sure the atomizer spins smoothly.

Ensure the adjustable chute is fitting

completely into the drum opening.
Adjust if necessary.
Page 44
LPH800 TREATER
ATOMIZER
Atomizer Head
Bearing
Quick-Release
Handle
Set Screw