USC LPX300 Operator's Manual page 160

1. Keep safety labels clean and legible at all times.
2. Replace safety labels that are missing or have become illegible.
3. Replaced parts that displayed a safety label should also display the current label.
4. Replacement safety labels are available. Contact USC at (785) 431-7900 .
How to Install Safety Labels:
Be sure that the installation area is clean and dry.

Be sure temperature is above 50

Decide on the exact position before you remove the backing paper.

Remove the smallest portion of the split backing paper.

Align the sign over the specified area and carefully press the small portion with

the exposed sticky backing in place.
Slowly peel back the remaining paper and carefully smooth the remaining

portion of the sign in place.
Small air pockets can be pierced with a pin and smoothed out using the piece of

sign backing paper.
Page 12
LPH800 TREATER
SAFETY LABELS
o
F (10
Located on the USC equipment you will find safety labels.
Always be sure to read and follow all directions on the labels.
Part # 09-02-0001
Guards provided with USC equipment are to remain in place
during operation.
o
C).
Part # 09-02-0002