Garmin G2000 Pilot's Manual page 88

Flight instruments
Adjusting the selected heading:
Turn the HDG Knob to set the selected heading.
Press the HDG Knob to synchronize the bug to the current heading.
Adjusting the Selected Course:
Turn the CRS Knob to set the Selected Course.
Press the CRS Knob to re-center the CDI and return the course pointer to the bearing of the active waypoint or
navigation station (see OBS Mode for adjusting a GPS course).
Selected
Heading
Navigation angles (track, heading, course, bearing) are corrected to the computed magnetic variation or
referenced to true north (denoted 'T'), and are set on the GTC Avionics Setup Screen. When an approach
referenced to true north has been loaded into the flight plan, the system generates a message to change the
navigation angle setting to 'True' at the appropriate time.
Changing the navigation angle setting:
1) From the Home Page touch Utilities >Setup > Avionics Settings.
2) Touch the Units Tab.
3) Touch the the Nav Angle Data Field.
4) Touch the desired setting (Magnetic or True).
74
This manual downloaded from http://www.manualowl.com
Current Heading Heading Bug
Figure 2-17 Heading and Course Indications (Magnetic)
Figure 2-18 Heading and Course Indications (True)
Garmin G2000 Pilot's Guide for the Cessna T240
Selected
Course
190-01263-01 Rev. A