Garmin G2000 Pilot's Manual page 448

Hazard avoidance
4) Touch the Map Settings Button.
5) Touch the Labels Button to enable/disable the display of labels on traffic (such as relative altitude).
6) To change the map range above which the system removes traffic symbols from the map, touch the Symbols
Range Button, then scroll to and touch to select a map range above which the system will remove the traffic
symbols.
7) To change the map range at which the system removes traffic labels from the map, touch the Labels Range
button, then scroll to and touch to select a map range above which the system removes traffic labels from the
map.
8) When finished, touch the Back or Home.
SySTEM STATUS
The traffic mode appears in the upper right corner of the Traffic Map Pane.
Mode
TAS System Test
Initiated
TAS Operating
TAS Standby
TAS Failed*
* See Table 6-26 for additional failure annunciations
If the traffic unit fails, the system shows an annunciation as to the cause of the failure in the center of the
Traffic Map Pane. During a failure condition, the Operating Mode is not available.
Traffic Map Page Center
434
This manual downloaded from http://www.manualowl.com
Traffic Mode Annunciation
(Traffic Map Pane)
TEST
(TEST MODE shown in top center of Traffic Map display)
OPERATING
STANDBy
(also shown in center of Traffic Map display)
FAIL
Table 6-25 Traffic Modes
Annunciation
NO DATA System is not receiving any data from the TAS unit.
System is receiving data from the TAS unit, but the
DATA FAILED
unit is reporting a failure.
FAILED The TAS unit is sending invalid data to the system.
Table 6-26 Traffic Failure Annunciations
Garmin G2000 Pilot's Guide for the Cessna T240
Traffic Display Status Icon
(Other Maps)
Description
190-01263-01 Rev. A