Advertisement
Or, fr om your PC scr een:
If alignment was initiated from the PC
Enter the numbers for all the patterns into the
Align Car tridges dialog box
Click OK .
To clean the print nozzles
Load plain paper in the printer.
Either, at the BT MultiJet 3000:
Print a nozzle test page using the front control panel:
Scan
Press and hold the Scan button for 3 seconds.
The display will show CARTRIDGE ALIGN?
Scan
Press and release the Scan button again. The
display will show CARTRIDGE CLEAN?
Press the Star t/Yes button. The nozzle
test page is printed.
Yes
Or, from your PC
Open the Control Program via Star t, Settings,
Printer s
, right click MJ3 printer icon and select MJ3
Contr ol Pr og r am
Click on Car tridges tab
Select Clean Print No zzles .
The nozzle test page is printed.
All manuals and user guides at all-guides.com
.
Compare the diagonal line above the printed bars to the
diagonal line below the printed bars. Look for a break in
the diagonal lines above the printed bars. A broken line
indicates clogged nozzles. If the bottom line still has
breaks, run the test up to two more times.
If the print quality is satisfactory after running the test
three times, the print nozzles are clean and you do not
need to wipe them.
If the print quality of both lines is not satisfactory after
running the test three times, wipe the print cartridge
nozzles as shown below.
Advertisement
