Advertisement
Enabling email and fax after installation
If, during installation, you did not choose to configure
Unimessage for fax and/or email, you can now enable
these features using the procedures below.
If you have neither fax or email
add one or both, go to
Ad d fax and/or email
If you have fax set up and want to ad d email
need to replace the existing modem configuration with
one that can perform both functions then delete the
original one. Follow instructions at
to fax
If you have email set up and want to ad d fax
Ad ding fax to email
to
Adding email to fax and adding fax to email
If you want to add email and fax start at step 1. If you
want to add fax only, start at step 18.
1. Open the Welcome screen.
2. Click Br owse Folder s .
You first need to set up your email account and servers:
3. Click Set Up .
4. Click Email .
5. Click the Accounts tab.
All manuals and user guides at all-guides.com
set up and want to
, you
Ad ding email
, go
6. Click Ad d .
7. Enter a name for your account, e.g. mymail.
8. Enter your Email address.
9. Enter your Reply address: normally the same as your
email address unless you want replies to go to
another address.
10. Click the Ser ver s tab.
11. Under incoming mail, enter your POP3 account name
and password (the ones you use for receiving mail).
12. Click OK . The Email setup screen is shown.
13. Click the Ser ver s ta b .
14. Click Ad d .
Unimessage Pro can receive email messages from
mailboxes on POP3 email servers and send email
messages via SMTP email servers.
15. Enter the SMPT (outgoing mail) server name.
Click OK .
Note
If your SMPT and your POP3 servers have the same
name, you can select Both to enter them both at
once.
Advertisement
