Table of Contents
Advertisement
8.3
Unit
The illustration below describes the menu of the unit. Menu items of the lowest menu level are
displayed in a bold frame. Menu items displayed only under certain circumstances are grayed out.
Unit (see below) ——
The unit is used for measured-value display and for all corresponding settings in the parameterisation
mode. The selection of the sensor type determines which units are available (see section 8.2.1). In
some cases, the selected measuring type is also relevant (see section 8.2.6):
•
for RTD and TC: °C, °F, K
•
for voltage: mV
•
for potentiometer, 5-wire: Ratio,
•
for potentiometer, 3-wire: Ratio
•
for potentiometer, 2-wire:
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
Temperature converter with trip relays KF**-GUT-(Ex)1.D
°C
°F
K
mV
Ratio
Ohm
Ω
Ω
Editing device data: Unit
Copyright Pepperl+Fuchs, Printed in Germany
29
Advertisement
Table of Contents
