Installing An Expansion Transmitter Module - Emerson PACSystems VersaMax User Manual

PACSystems VersaMax Genius Network Interface User Manual
GFK-1535D
2.5 Installing an Expansion Transmitter
Module
If the I/O Station will have more than one expansion rack or one
expansion rack that uses an Isolated Expansion Receiver Module
(IC200ERM001) as its interface to the expansion bus, an Expansion
Transmitter Module must be installed to the left of the NIU. The
Expansion Transmitter Module must be installed on the same section of
the DIN rail as the rest of the modules in the main "rack" (rack 0).
Figure 15: Expansion Transmitter Module Installation
1. Make sure the rack power is off.
2. Attach the Expansion Transmitter to the DIN rail to the left of the
3. Install the NIU as instructed. Connect the modules and press
4. After completing any additional system installation steps, apply
Figure 16: Power Indicators
Installation
NIU position.
them together until the connectors are mated.
power and observe the module LEDs
Section 2
Jan 2023
23