Emerson PACSystems VersaMax User Manual page 110

PACSystems VersaMax Genius Network Interface User Manual
GFK-1535D
Offset (Byte
#)
74, 75
76, 77
78, 79
80, 81
82, 83
84, 85
86, 87
88, 89
90, 91
Example Configuration Message for IC200ALG266
The configuration data format of the 15-channel analog voltage module
is shown below. By specifying an offset, as listed in the left column, and a
length in bytes, any portion of the configuration data can be read or
written.
Offset (Byte #) Byte description
0,1
2, 3
4,..,7
8, 9
10,.., 23
24, 25
26, 27
28, 29
30,31
32, 33
34, 35
36, 37
38, 39
40
41
42, 43
44, 45
Configuration
Byte description
Default input for analog channel #8
Default input for analog channel #9
Default input for analog channel #10
Default input for analog channel #11
Default input for analog channel #12
Default input for analog channel #13
Default input for analog channel #14
Default input for analog channel #15
Must be 8001h
Secondary board ID (must be 0xFFFF)
Primary board ID (must be 0x0F94)
Module ID string –"A266" (41h, 32h, 36h, 36h)
Modules configuration length (must be 66)
Reserved. (must be 00h)
Length of additional data (must be 78)
Secondary board ID (must be 0xFFFF)
Primary board ID (must be 0x0F94)
Module-dependent offset (must be 64)
Number of discrete input segments (must be 0000h)
Number of discrete output segments (must be 0000h)
Number of analog input segments (must be 0001h)
Number of analog output segments (must be 0000h)
Module setup, a bitmapped word. bit 0 indicates whether defaults are
defined in the configuration structure. If this bit is '1', then input segments
mode, output segments mode, default input values, and default output
values fields are included below.
bit 1 enables fault reporting for the module. bits 2-15 are reserved and must
be set to zero.
Must be 00h
Extra hardware offset (must be 0000h)
Module-dependent length (must be 0002h)
Section 5
Jan 2023
104