Assembly Completion - 3M Matic 800at Instructions And Parts List

7-INSTALLATION (continued)
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks (Figure 7-4).
Figure 7-4
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame (Figure 7-5).
Figure 7-5
Figure 7-7
800at-NA
Cut the plastic ties holding the lower taping head in
position (Figure 7-6).
Figure 7-6

7.6 Assembly Completion

1 Crank - Install the crank handle on the top of
the left column as shown (Figure 7-7A).
2 Tape Drum Bracket - Install the upper tape
drum bracket on the top cross bar as shown
(Figure 7-7B).
3 Stop Bracket - Raise upper head assembly
(turn crank handle counterclockwise) and install
the two stop brackets (provided in the parts
bag). Use lower set of holes as shown in Fig
ure 7-7D. The upper set of holes should only be
used when both taping heads are adjusted to
apply 50mm tape legs.
18
2011 February