Theory Of Operation; Emergency Stop - 3M Matic 800at Instructions And Parts List

8-THEORY OF OPERATION

8.1 Description of the Working Cycle
After having closed the top fl aps of the carton, the
operator pushes it under the top infeed end in order
to avoid the opening of the top fl aps. Further push-
ing causes the two bottom side belts to drive the
box through the taping heads which automatically
seal the top and bottom seams. The carton is then
expelled on the exit conveyor.
8.2 Defi nition of Running Mode
The case sealer 800at-NA has only one (automatic)
operating mode with:
- The EMERGENCY STOP BUTTON unlocked
(Figure 8-1)
- The main switch start switch "ON"
(Figure 8-2)
8.3.1 Normal Stop Procedure
When the main switch is OFF, the machine stops
immediately at any point of the working cycle. The
same thing happens in case of electrical failure or
when the machine is disconnected from the mains.

8.3.2 Emergency Stop

The LATCHING EMERGENCY STOP BUTTON is
located on the top center of the machine
(Figure 8-1).
800at-NA
Figure 8-1
Figure 8-2
Belt
Direction
20
E-Stop Location
Figure 8-3
2011 February