Assembly Completion / Machine Setup - 3M -Matic 700r3 Instructions And Parts List

7-INSTALLATION (continued)
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks (Figure 7-4).
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame (Figure 7-5).
Figure 7-4
Figure 7-5
Cut the plastic ties holding the lower taping head in
position (Figure 7-6).
700r3-NA

7.6 Assembly Completion / Machine Setup

1. Install the upper tape drum bracket on the top
crossbar as shown in Figure 7-7A.
2. The column guards, shown in Figure 7-7 have
been installed upside down for shipping. Remove
and retain the screws and washers holding the
guards on the columns for re-installation after
the Bumper Supports have been mounted (see
Column Bumper Installation in the Installation
and Setup Section and Special Setup Procedures
Section / Figure 7-7). After the Bumpers have
been installed, the Column Guards must be
repositioned (rotated 180° and re-installed -
Figure 7-7) for safe operation of the machine.
Replace existing screws and washers to secure
the guards in place.
3. Cut cable ties securing upper assembly to
machine bed on each side.
20
Figure 7-6
2012 January