Maintenance; Blade Replacement; Blade Guard; Blade Oiler Pad - 3M Matic 800at Instructions And Parts List

Maintenance

•
To reduce the risk associated with shear, pinch, and entanglement hazards:
−
Turn air and electrical supplies off on associated equipment before performing any adjustments,
maintenance, or servicing the taping heads
−
Never attempt to work on the taping head or load tape while the box drive system is running
•
To reduce the risk associated with sharp blade hazards:
−
Keep hands and fi ngers away from tape cutoff blades under orange blade guards.
The blades are extremely sharp
The AccuGlide™ 2+ STD 2 Inch Taping Head has
been designed for long, trouble free service. The
taping head will perform best when it receives routine
maintenance and cleaning. Taping head components
that fail or wear excessively should be promptly
repaired or replaced to prevent damage to other
portions of the head or to the product.
Blade Replacement, Upper and Lower Taping Heads
– Figure 4-1
WARNING
•
To reduce the risk associated with sharp
blade hazards:
-
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp
1. Loosen, but do not remove, the blade screws (A).
Remove and discard old blade.
2. Mount the new blade (B) with the beveled side
away from the blade holder.
Knife
Guard
Figure 4-1 – Blade Replacement
2" STD Taping Head
WARNING
3. Bottom the blade slots against the screws. (This
Note – Check the blade position to insure proper

Blade Guard

The blade guard covers the blade whenever a box
is not being taped. Periodically check to be sure the
blade guard is functioning properly and returning to
cover the blade. Replace any defective parts.

Blade Oiler Pad

The taping heads are equipped with a felt oiler pad
that has been pre-lubricated at the factory to
provide a fi lm of oil on the cutting edge of the blade
to reduce adhesive build-up. Apply SAE #30 non-
detergent oil as needed. Saturate felt oiler pad.
Should tape adhesive build-up occur on blade,
carefully wipe clean with an oily cloth.
Knife
Holder
12
will position the blade at the correct angle.)
Tighten the blade screws to secure the blade.
clearance between blade and guard by
slowly pivoting the blade guard back.
WARNING
•
To reduce the risk associated with sharp
blade hazards:
-
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp
(Maintenance continued on next page.)
2010 May