Table of Contents
Advertisement
I R R E M O T E C O N T R O L
This unit can be operated using the ADJ UC IR24 remote control. Please note that this unit can
only be controlled when it has been set to Primary mode. The unit will NOT respond to com-
mands when it has been set to Secondary mode. When using the UC IR24 to control multiple units
that are operating in primary/secondary mode, follow these steps to set up the units:
1. Power on the unit, and press MODE to scroll to the "Personality" menu, then press ENTER.
2. Use the UP and DOWN buttons to scroll to "Prim/Sec Mode". Press ENTER, then use the UP and
DOWN buttons to toggle between "Primary" and "Secondary".
3. Press ENTER to confirm and return to the "Personality" menu.
4. Use UP and DOWN to scroll to "WiFly Settings" and press ENTER.
5. Use the UP and DOWN buttons select "Set WiFly Channel." Press ENTER and use UP and
DOWN to set the unit to your desired WiFly channel. Repeat these steps for each unit. Please
note that all units should be set to the same Wifly channel.
NOTES:
•
Only one unit should be configured as the primary, while all the other units should be configured
as secondaries.
•
All units in the system should be set to the same WiFly channel. If all units are set to the same Wi-
Fly channel, and the units do not sync up and/or respond to commands, try using a different WiFly
channel.
•
All units should be set to the same DMX channel mode.
•
If fixtures fail to sync, verify that all settings mentioned above are the same, then power all devices
off, then switch them on again to re-establish the link.
CONTROLS
•
ON and OFF: When the ON button is pressed, the lighting fixture shall
return to its last running state. When the OFF button is pressed, the unit
shall go into stand by mode in a blackout state.
•
STROBE: The unit shall strobe the selected color or program. The
strobe rate can be adjusted with the + / - buttons. Buttons 0-15 are used
to select the color.
•
SOUND: Triggers the selected program steps based on sound input.
The microphone sensitivity can then be adjusted with the +/- buttons.
•
COLOR: When the color button is pressed, preset static colors can
be selected using buttons 0-15. The intensity for the set color can be
adjusted with the +/- buttons.
•
PROGRAM: When the program button is pressed, internal programs
can be selected by pressing buttons 0-15. The selected program's
speed can be adjusted with the+/- buttons.
•
+ and - buttons: These buttons are used to adjust strobe rate, mic sen-
sitivity, brightness intensity, or program run speed, depending on which
mode is active. Single-level adjustments can be made with individual
buttons presses, while large adjustments can quickly be made by press-
ing and holding.
•
0-15 buttons: These buttons are used to select preset static colors or
internal programs, depending on which mode is active. Colors stored in
buttons 0-15 can be edited from the units menu if desired.
14
Advertisement
Table of Contents
