Installation - ADJ ELEMENT H6 PAK User Manual

Hide thumbs Also See for ELEMENT H6 PAK:
Table of Contents

Advertisement

I N S T A L L A T I O N
IP RATING
The ELEMENT H IP is IP54 rated. Ingress of dust is not entirely prevented, but it will not enter in suf-
ficient quantity to interfere with satisfactory operation of the device. The ELEMENT H IP is also pro-
tected against splashing water from any direction. Please note that the charging devices and flight
case are not IP-rated, and are intended for use in dry, indoor conditions only.
FLAMMABLE MATERIAL WARNING!
Keep device a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The unit MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Before installing or mounting any device, a professional equipment installer MUST be consulted to
determine whether the mounting structure or surface is properly certified to safely support the com-
bined weight of the fixture, clamps, cables, and accessories.
Operating temperature range is -4 to 113 degrees F (-20 to 45 degrees C). Do not operate the de-
vice if ambient temperatures fall outside of this range.
This fixture should be installed away from walking paths, seating areas, and areas where unauthor-
ized personnel might be able to reach the device by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing.
Allow approximately 15 minutes for the fixture to cool down before servicing.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Element h6 pak chr

Table of Contents