Uc Ir Remote | Controls - ADJ ELEMENT Series User Instructions

U C I R R E M O T E C O N T R O L
The UC IR (sold separately) infrared remote gives you control of various functions (See below). To
control the fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.
To use the ADJ UC IR you must first activate the fixtures infrared sensor, to activate the sensor please
see the instructions on page #.
C O N T R O L S
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the initial
state.
FULL ON - Press this button to fully light up the unit.
FADE/GOBO - This button can activate color change mode, color fade mode, or combination color
change and fade mode. Each press of the button will switch through the 3 different modes. Use the
numeral buttons 1-9 to select the program number within your desired mode. Use the dimmer buttons
to adjust the output intensity. Note: Running speed is not adjustable using the IR control functions.
Example: In color change mode (AJXX), press the numeral buttons "1+3"
to run color change program "13". In color fade mode (AFXX), press the
numeral button "7" to run color fade program "7". Note: Color change and
fade combination mode has only one program.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output
intensity in operating mode.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust
the strobe speed. "1" being the slowest, "4" being the fastest.
COLOR - Press this button to activate color macro mode. Use the numeral
buttons 1-9 to select your desired color. Use the dimmer buttons to adjust
the output intensity.
Numeral Buttons 1-9 - Use buttons 1-9 to select your desired color in static
color mode, or your desired program in color fade mode and color change
mode. In static color mode, color fade mode, or color change mode, press
the corresponding numeral buttons to select your desired color or program.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button along with any single numeral button to access a static color, or program
within color change mode and color fade mode.
12