Connectors - Video Interface; Dip-Switch Settings - NavLinkz RL2-SC14 Manual

1.3. Connectors – video interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options.
1.4.

Dip-switch settings

Some settings must be selected by the dip-switches on the
video-interface. Dip position down is ON and position up is OFF.
Dip Function
1 No function
2 Front camera/Video IN 1 input
3 Video IN 2-input
4 No function
5 Rear-view cam type
6 Front camera
7 No function
8 Factory PDC
*The front camera will automatically be switched for 10 seconds after disengaging the
reverse gear.
After each Dip-switch-change a power-reset of the Interface-box has to be performed!
See following chapters for detailed information.
Version 09.02.2023 HW: CAM(V31)9275&9276(V11) since serial-no. NA210400258 with frontcam input
ON (down)
-
enabled
enabled
-
after-market factory or none
enabled*
enabled
OFF (up)
set to OFF
disabled
disabled
set to OFF
disabled
set to OFF
disabled
RL2-SC14