Table of Contents
Advertisement
Continued
Press t he [SOLUTION], [BRAND] or [SEARCH] key t o
4
select a m et hod of program m ing.
There are three methods to program the preset code. For details on each
method, go to the page indicated below. Try [SOLUTION] first. If the
preset code cannot be confirmed with [SOLUTION], try [BRAND], then
[SEARCH].
[SOLUTION]: Use the remote control supplied to the component to be
[BRAND]:
[SEARCH]:
44
Downloaded from:
Program m ing t he preset codes of com ponent s (PRESET)
registered.
Place the Remote Commander head to head with the
remote control of the component to be registered as
illustrated below.
Remote control signals of the component to be registered
is received by the Remote Commander, then registering
can be simply performed by searching automatically a
preset code.
Remote control of
the component to be
registered
Infrared detector
Conf irm t he locat ion of t he det ect or of t he Remot e
Commander. When t he AC pow er adapt or is connect ed t o
t he Remot e Commander, make sure t hat t he det ect or is not
shut off by t he cord.
t Go to page 45.
Program a preset code by selecting a component brand
from the brand list.
Even if there are multiple preset codes in the brand of the
component to be registered, you can confirm the preset
code by performing a test execution. After this, it will not
be necessary to set again.
t Go to page 48.
Program a preset code by selecting a preset code from the
component code list and performing test execution one by one.
You can search a preset code with this method even when
you have not a remote control of the component to be
registered, or you cannot find a brand name of the
component to be registered in the brand list.
t Go to page 50.
https://www.usersmanualguide.com/
About 5 - 10 cm
(2 - 4 inches)
RM -NX7000
Advertisement
Table of Contents
