Programming Signals Of Another Remote Control - Learning Function - Sony RM-VL700T Operating Instructions Manual

Programming signals
of another remote
control — Learning
Function
To operate components or
functions which do not work even
if you set a component code
number, use the following
Learning procedure to "teach" any
of the programmable buttons or
the Commander to operate the
functions of another remote
control. You can also use the
Learning function to change the
signals of individual buttons after
setting the component code
number (page 8).
It is recommended that you make
a note of the "learned" key
functions. (It is possible to make a
note on the back of the supplied
"Component Code Numbers.")
Notes
• Some specific remote control signals
may not be "learned."
• You can also use a display monitor
for computer display (including a
built-in tuner type), if the
Commander is "learned."
Example: To programme the N
(Play) signal of your video
cassette recorder to the VCR N
(Play) button of the Commander
1
Place the RM-VL700T head
to head with your
component's remote
control.
Remote control for
your component
about 5 -10 cm
(2 -4 inches) away
2
Press and hold SET for over
3 seconds.
The SET indicator lights up,
and all Component Select
buttons flash.
2,7
4
3
4
RM-VL700T
Continued
GB
15