Set Qos; Set Ieee 802.1X - HIKVISION DS-2DF7C445IXR-AEL(T5) User Manual

Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Before You Start
Install client and CA certificates before configuration. Refer to Certificate Management for
●
detailed information.
Select certificates according to the requirement of the log server. If two-way authentication is
●
required, select the CA certificate and the client certificate. If one-way authentication is
required, select the CA certificate only.
Steps
1. Check Enable Log Upload Server.
2. Optional: Check Enable Encrypted Transmission if you want the log data to be encrypted.
3. Input Log Server IP and Log Server Port.
4. Optional: Select client certificate.
5. Select CA certificate to the device.
6. Click Test to test the settings.
7. Click Save.

11.12.6 Set QoS

QoS (Quality of Service) can help improve the network delay and network congestion by setting
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1. Go to Configuration → Network → Advanced Configuration → QoS .
2. Set Video/Audio DSCP, Alarm DSCP and Management DSCP.
Note
Network can identify the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. You need to set the same value in router while configuration.
3. Click Save.

11.12.7 Set IEEE 802.1X

You can authenticate user permission of the connected device by setting IEEE 802.1X.
Go to Configuration → Network → Advanced Settings → 802.1X , and enable the function.
Network Speed Dome User Manual
101