Table of Contents
Advertisement
4. Click Area Settings to set the detection rule.
5. Select a detection scene from the drop-down list and change the Scene Name as required.
The device supports multiple detection scenes with independent detection parameters.
6. Draw lane areas in the scene.
1) Click Lock to avoid accidental PTZ changing during configuration.
2) Adjust the pan, tilt, and zoom position to obtain the target scene.
3) Select the Total Number of the Lanes according to the actual lane number you want to
monitor in the scene.
Yellow lane lines, a blue detection line, and a red frame are displayed on live image.
4) Adjust the zoom ratio of the device so that the size of the vehicle in the image is close to that
of the red frame. The position of red frame is adjustable.
5) Click and drag the lane lines or the endpoints to set the positions according to the actual lane
lines on the road.
6) Optional: Click and drag the blue detection line to adjust the position. Vehicle detection is
triggered when target vehicles hit the line.
7) Click Save.
7. Optional: Repeat to set other detection scenes if needed.
8. Set detection parameters.
Country/Region
Select according to the device location. License plate rules of the selected country or region
are activated.
Detection Mode
The device is able to detect vehicles and license plates. With the detection mode settings, the
detection priority of the vehicle and license plate can be adjusted on demand.
License Plate & Vehicle
The vehicle and license plates are detected simultaneously. The device takes a capture
either when it detects a vehicle or a license plate.
Vehicle Priority
The device takes a capture only when it detects a vehicle.
Remove Duplicated License Plates
The function is used to avoid repeated captures of the same license plate. Set the Time
Interval. During the set interval, the same license plate is only captured once.
9. Click Save to finish area settings.
10. Set the arming schedule for allowlist, blocklist, and other list respectively.
1) Click Arming Schedule.
2) Select a detection scene and draw the time bar in the time table. Different scenes are
marked with different colors on schedule.
3) Optional: Move the mouse to the end of each day, a copy icon pops up, and you can click to
copy the current settings to other days.
4) Click Save after finishing schedule settings.
Network Speed Dome User Manual
9
Advertisement
Table of Contents
