Assemble Kits; Assemble Sector Controller With Rf Splitter; Figure 35: Assembly- Sector Controller With Rf Splitter - Redline RDL-3000 Installation Manuallines
Ellipse tma sector controller multi-sector system (uwt) system
Hide thumbs
Also See for RDL-3000:
- User manual (150 pages) ,
- Installation manuallines (65 pages) ,
- Configuration instructions (9 pages)
Table of Contents
Advertisement
RDL-3000 Ellipse TMA Sector Controller Installation Guidelines
6
Assemble Kits
The major system components should be assembled from the supplied kits and be
tested and weatherproofed before final installation.
6.1
Assemble Sector Controller with RF Splitter
The sector controller and RF splitter kit are supplied separately and must be bolted
together, cables attached, and weatherproofing applied before final installation. Locate
all parts from both kits before assembling the unit.
Note: The single RF connector on the splitter mates to the RF connector on the top of
the Ellipse TMA sector controller. Make these connections before bolting the splitter to
the mounting plate.
70-00159-02-00
Figure 35: Assembly- Sector Controller with RF Splitter
Proprietary Redline Communications © 2014
Chapter 6
Page
42
of 59
July 18, 2014
Advertisement
Table of Contents
