Table of Contents
Advertisement
Hardware Manual
Gently set the stage on a smooth, flat, and clean surface. Use compressed nitrogen or clean, dry, oil-
free air to remove any dust or debris that has collected during shipping.
Before you operate the stage, let it stabilize at room temperature for at least 12 hours. This will
ensure that all of the alignments, preloads, and tolerances are the same as they were when they
were tested at Aerotech.
Each stage has a label listing the system part number and serial number. These numbers contain
information necessary for maintenance or system hardware and software updates. Locate this label
and record the information for later reference.
Red, anodized aluminum shipping brackets have been installed to prevent unwanted motion
damage that could occur during shipment. The brackets must be removed before the ANT130LZ can
be operated. Retain the brackets and hardware for future use.
DANGER: Mechanical Hazard!
The product can move manually without electrical power connected.
l
When the shipping brackets are removed, the operator could be exposed to pinch
l
points.
Figure 3:
Shipping Brackets
Storage
Store the stage in the original shipping container. If the original packaging included ESD protective
packaging, make sure to store the stage in it. The storage location must be dry, free of dust, free of
vibrations, and flat.
Refer to
Section 1.1. Environmental Specifications
www.aerotech.com
ANT130LZ
15
Advertisement
Table of Contents
