Table of Contents
Advertisement
2.1
Installation
Assembly with AIIS-3411
To assemble the AIIS-1882 board in the AIIS-3411 computer, you should
1.
Open the enclosure, screw sets and the front panel
2.
Assemble the AIIS-1882 board in the chassis, lighting cables to the front panel,
finally the I/O panel back to the front panel
Please follow the steps below to open the enclosure, screw sets and the front panel:
1.
Remove the screws on the rear side of AIIS-3411
2.
Remove the top enclosure of AIIS-3411
3.
Remove 4 screws around the expansion connectors
4.
Remove the screws of the I/O panel
5.
Remove I/O panel
Figure 2.1 Disassembling the enclosure of AIIS-3411
Then, assemble the AIIS-1882 board in the chassis, lighting cables to the front panel,
finally the I/O panel back to the front panel:
1.
Screw the four screw posts back into the holes that they came from.
2.
Remove the release paper from the supporting pad, then stick it onto the place
indicated in figure 2.4.
3.
Place the AIIS-1882 into the chassis, then press to connect the board-to-board
connector right onto the top of the assembly.
4.
Affix the screws back to the board on the corners.
AIIS-1882 User Manual
6
Advertisement
Table of Contents
