Network Settings Page Definitions; Ethernet Settings - Grandstream Networks GSC3505 Series User Manual

Group Paging
Allows to configure the group paging IP address.
Address
Port Configures port number for group paging address.
IGMP Keep-
Specifies how often the phone reports IGMP when Group Paging function is turned on. IGMP report
alive Interval
helps to keep Group Paging alive in sleep state.
(s)
Emergency
Group Paging Configures default volume for group paging when emergency channel/group is used.
Volume
Paging Config
Group Paging Allows to enable or disable group paging.
Configures priority paging group. Paging received on priority group will take precedence overactive
Priority Group
paging on normal group.
Emergency Set emergency group for paging. Emergency group has the highest priority. Paging using emergency
Group group will take precedence over paging on priority or normal group.
Configures whether to accept paging while device is in active call. If set to "No", device will ignore paging
Accept While
while in active call. If set to "Yes", while in active paging call, the device will accept other paging calls if it
Busy
has the same priority. If device is in an active SIP call, device will accept paging and hang up the SIP call.
Configures paging group. Users can configure whether to use the group to accept and join group, and its
Group label. Only available and joined group will be displayed in paging group list. If users need receive paging,
"Subscribe" must be enabled for this group.

Network Settings Page Definitions

Ethernet Settings

Preferred
If IPv4 is selected, the device will be using IPv4 addressing, otherwise, it will be using IPv6 addressing.
Internet
Default is Prefer IPv4.
Protocol
Different
Configures whether to set up different networks for the phone data and the call. If set to "Yes", you need
Networks for
to configure the data network and VoIP network respectively.
Data and VoIP
Note: Reboot is required to take effect.
Calls
IPv4